Swinging gate for crowd control security passage

This Crowd Control Security self-closing Gate swings to both sides to avoid frequent damage of such
one-directional gates. It can be mounted on Lavi Beltrac grooved stanchions.
Ideal for Airport checkpoints, and other places where one-way pedestrian traffic is required.
NOTE: Stanchions are sold separately.

Messaging

Standard Messaging

The Gate comes in plain black or with standard messaging: "Please Wait Here" on the entry side and the international "Do Not Entry" symbol on the other side.
Any Configuration of these two messages is available at no additional cost. Add your comments when placing the order or contact us with your request.

Custom Messaging

You can CUSTOMIZE the gate with a one time $350 setup fee for two-color artwork on both sides.

The fee is charged per design, if you order multiple gates with the same design you will only be charged one time. Order online and email us graphics or a description of what you want to be printed on the gate. We will send you a mock-up for your approval before producing a custom message. Please inquire for more details.

FAQ

Q. Do you have a gate than only swings in one direction?

A. No, we've discontinued making it, because people would break them all the time. This gate swings in both directions.

• • Material: Sintra (Black)
  • Weight: 2 lbs.
  • Height: 12" in.
  • Width: 32" in.
  • Thickness: 1/4" in.
  • Panel measurements : 30" x 12"

Mounting Options

#1 Mounting to a crowd control stanchion (Lavi Beltrac 3000)

Assembly Instructions:

1. Loosen the two socket head cap screws in the 12" long grip connector with the Allen wrench.

2. Open the full-length dovetail of the grip connector to the dovetail of the post and rotate into place to engage the two dovetail brackets (push the head of the screw to maneuver the bracket).

3. Open top of grip connector to top of the post (just below the mechanism cap) and tighten screws to secure in place.

NOTE: if a squeaking noise develops at any time during a deployment, simply apply a small dab of grease to the bearing surfaces.

#2 Mounting to a wall

To mount the gate to a wall or another flat surface use 2 x Beltrac Stanchion Belt End Receptacles. Install the receptacles on the wall and follow the same steps as above.